Auto Pilot Vertical Artikkelnr.: 20003739 NOK10 736,25 inkl. mva. Antall Kjøp Ønskeliste Del dette Produktinfo A stepper motor based system with two servo motor units which can be used in conjunction with Nesis or Aetos. Amigo Autopilot unit Amigo is a simple control panelfor autopilot system. Bright, easyto read display and intuitive buttonarrangement. Offers 2-axis (pitch and roll)capabilities. Amigo weighs 180 g. Two orientation options You can install your Amigo vertically or horizontally, based on your prefference. Illuminated buttons Buttons are backlit and offer sharp feedback. Two rotating push knobs Direct control of heading and altitude through two rotating push knobs. Servo`s Servo units Servo features: Precision machined and anodized solid Aluminum housing Output shaft runs inside double ball bearings CAN bus interface Mounted position limiter Seperate power supply Wide input voltage range (9 V – 32 V ) Output arm equipped with safety shear screw 4 mounting holes to simplify instalation Stepper motor based, single stage spur gear 8 holes to fit travel limiting bolts/plate (preventing “over center” lock-up) 360 degree freedom of movement Direct motor overdrive Weighs from 1760 g to 2180 g. Two sizes available The small servo is mostly used for aileron controls with 3 Nm torque, and the bigger servo for elevator control with 6 Nm torque. Shear screw Output arm equipped with safety shear screw. Position limiter Limiting plate which prevents over center lock-ups.