Floating ground type for when the engine block does not provide the earth. (One terminal to earth, the other to a gauge.) On Rotax engines this sender is used if the Flydat instrument is...
Electrolytic Capacitor - 22, 000 uF 40V and absolute requirement to prevent regulator spikes on Rotax, Jabiru and other engines, the manufacturer recommend installing the electrolytic capacitor in...
The IM-105 instruments have been designed especially to measure the RPM in Rotax® engines 912 and 914.
The IM-105 is available in 57 mm diameter.
The instruments have been designed...
The IM-1106 instruments have been designed especially to measure the RPM in Rotax® engines 912 and 914.
The IM-1106 is available in 57 mm diameter. (2 1/4 Inch)
The instruments...
The IM-3108 instruments have been designed especially to measure the RPM in Rotax® engines 912 and 914.
The IM-3108 is available in 57 mm diameter.
The instruments have been...
The IM-542 instruments have been designed especially to measure the Oil pressure in Rotax® engines 912/914 (Series).
The IM-542 is available in 57 mm diameter.
The instruments have...
The IM-3542 instruments have been designed especially to measure the pressure and Temperature Oil in Rotax® engines 912/914 (Series).
The IM-3541 is available in 57 mm diameter
A...
The IM-3541 instruments have been designed especially to measure the pressure and Temperature Oil in Rotax® engines 912/914 (Series).
The IM-3541 is available in 57 mm diameter.
A...
The IM-525 instruments have been designed especially to measure the Oil pressure in Rotax® engines 912/914 (Series).
The IM-525 is available in 57 mm diameter.
The instruments have...
The IM-528 instruments have been designed especially to measure the Oil Temperature in Rotax® engines 912ULS (100 HP) & 914.
The IM-528 is available in 57 mm diameter.
The...
Specifically designed to measure the coolant temperature in the ROTAX engine 912/914 with red , green and yellow zones.
In compliance with the Service Bulletin SB-912-066 , the red zone...
The IM-539 instruments have been designed especially to measure the Cylinder Heat Temperature (CHT) in Rotax® engines 912ULS/914.
The IM-539 is available in 57 mm diameter.
The...
The IM-777 instruments have been designed especially to measure the EGT in Rotax® engines 912.
The IM-777 is available in 57 mm diameter
Can be connected two probes. First shows...
IM-919 - Has a M8 thread and can be installed directly on the M8 nuts that come from the factory on 914 engines and some 912. In the exhaust without nuts, your need weld 4xM8 nuts. Stainless steel...
IM-920 - Has a M8 thread and can be installed directly on the M8 nuts that come from the factory on 914 engines and some 912. In the exhaust without nuts, your need weld 4xM8 nuts. Stainless steel...
M-929 -Probe type "K" Clamp type. Designed for 447/503/582 Rotax engines. No need weld nut, simply drill and tighten the clamp. Stainless steel protection. Wire length 2 meters.
The IM-551 instruments have been designed especially to measure the EGT in Rotax® engines 912.
The IM-551 is available in 57 mm diameter
Can be connected four probes. First shows...
The IM-779 instruments have been designed especially to measure the EGT in Rotax® engines 912.
The IM-779 is available in 57 mm diameter
Can be connected two probes. First shows...
The IM-552 instruments have been designed especially to measure the EGT in Rotax® engines 914.
The IM-552 is available in 57 mm diameter
Can be connected four probes. First shows...
The IM-567 instruments have been designed especially to measure fuel pressure in Rotax® engines 912.
The IM-567 is available in 57 mm diameter.
This instruments use...